FrostyTech.com Heatsink Reviews and Analysis
   
  

TOP 5 Heat Sinks     TOP 5 Low Profile Heat Sinks     TOP 5 Liquid Coolers    
 Heatsinks by Brand / Mfgr      Reviews + Articless     Advanced Search    

RJ-45 Crimpers Review
RJ-45 Crimpers Review
  77%   
Abstract: Plastic Ethernet crimpers may be cheap but they don't always work. These metal ones crimp cables fast and perfectly everytime. Which is much better than cheap :)

 Manufacturer  Category  Published  Author 
FrostyTech   Networking   Jun 23, 2000   Max Page  

RJ-45 Crimpers Review


The last time we looked at crimping RJ-45 jacks onto the ends of Cat-5 cables we were using an inexpensive orange plastic crimper. Although it appeared to be doing the job, we were finding problems with the cables when we tested them out with the Cat5 Tester. What we eventually found was that the cheap plastic crimper was not putting enough pressure onto the metal connectors of the RJ45 jack and they were not seating properly. The end result was a bunch of wasted time and cables which would change from good to bad with any movement of the wire or jacks. Not a good situation.

Around this time we were having some technicians in to install our connectivity. We managed to borrow their AMP crimping tool ($400) for a few minutes and recrimp some of our cables. Suffice to say the cables worked fine after one go through that massive metal monster crimper. It also became quite obvious that the orange crimper was only crimping the metal teeth in the RJ45 jack about 1/3 of the way down, which explained why the connections were so loose.

Biting the bullet we invested in an $80 pair of all metal generic crimpers. This particular pair has a spring loaded ratcheting feature so it is basically impossible to undercrimp a RJ45 connector. The crimpers have to be crimped fully before they will open up again and allow you to remove the jack. If you don't crimp enough, you won't be able to remove the jack from the die. Additionally the crimping die is well machined metal, which can be replaced should it ever become damaged. Removable razor blades on either side allow the cat 5 cable to be cut, and or the protective covering removed at the right distance for crimping.

These crimpers are more expensive than the orange pair were, but they actually work, and will continue to do so for quite some time. The crimp is a perfect one every time, and the wire is held firmly in the little plastic RJ 45 jack because of it. Most importantly the cat 5 cables actually work. :)

When it comes to connectivity and lost data that is of course the most important of all considerations.



Facebook RSS Feed Twitter
Resources
° Got Feedback?
° Mk.II Test Platform
° Where To Buy?
° Manufacturer Index
° Industry Dir.
° Cooling Projects
Recently Tested

Arctic Liquid Freezer 120 CPU Watercooler Review

Scythe Mugen 5 Rev B SCMG-5100 Heatsink Review

Gelid Tranquillo 4 Air Cooled Heatsink Review

Coolermaster Ergostand III Laptop Cooling Stand Review

Noctua NH-D9DXi4-3U LGA2011 Xeon Server/Workstation Heatsink Review

Noctua NH-L9x65 Low Profile Heatsink Review
...More Articles >>


Websites you may also like:
PCSTATS

FrostyTech.com
Since June 1999


Find a Heatsink
Latest Heatsink Reviews
Top 5 Heatsinks Tested
Top 5 Low Profile Heatsinks
Top 5 Liquid Coolers
Heatsinks by Mfgr / Brand


Social Media
Facebook
Twitter
Pinterest


FrostyTech.com Info
Feedback
Contact Us / Heatsink Submissions
Submit News
Privacy Policy
Suite 66

© Copyright 1999-2024 www.frostytech.com All Rights Reserved. Privacy policy and Terms of Use
Images © FrostyTech.com and may not be reproduced without express written permission. Current students and faculty of accredited Universities may use Frostytech images in research papers and thesis, provided each image is attributed.